Connecting a laptop to a TV or projector

This is a guide for the five minutes before a presentation, a church service or a film night, when the projector says "no signal".

1. Match the ports

Look at the sides of the laptop and the back of the TV or projector.

PortLooks likeNotes
HDMIWide, flat, slightly taperedThe standard. Carries picture and sound
USB-C with DisplayPortSmall, ovalMany newer laptops. Needs a USB-C to HDMI adapter or cable. Not every USB-C port supports video; look for a small D or lightning-bolt symbol
VGABlue, trapezoid, 15 pinsOlder projectors. Picture only, no sound
Mini DisplayPort / ThunderboltSmall, one bevelled cornerOlder MacBooks. Needs an adapter

Buy or carry an adapter from your laptop's port to HDMI and, if you present often, one to VGA as well. Many venues still have old VGA projectors.

2. Connect and choose the input

  1. Connect the cable with both devices on.
  2. On the TV or projector remote, press Input or Source and choose the port you used (HDMI 1, HDMI 2, VGA/PC).
  3. On a Windows laptop press Windows key + P and choose a mode.
  • Duplicate shows the same thing on both screens. Best for most presentations.
  • Extend uses the projector as a second screen, so you can see your notes while the audience sees the slides.

On a Mac, open System Settings, Displays and choose to mirror or extend.

No picture

  • Check the input on the projector again. It is the most common cause.
  • Unplug and replug the cable with the laptop on.
  • Press Windows + P and choose Duplicate again.
  • Try another HDMI cable. Cheap cables fail more often than projectors.
  • Lower the laptop's resolution in Settings, System, Display if the projector is old.

No sound through the TV

Click the speaker icon on the taskbar and choose the TV or HDMI device as the output. VGA does not carry sound: connect a separate speaker to the laptop's headphone jack.

The picture is stretched or cut off

In Settings, System, Display, set the resolution to what the projector supports (often 1280 x 800 or 1920 x 1080), or set the TV's picture size to Just Scan or Screen Fit.

Presenting without cables

Many smart TVs and projectors accept wireless screen sharing. On Windows press Windows key + K to cast; from a phone see screen mirroring your phone to a TV. Wireless has a slight delay, so it suits slides better than video.

Before the event

Arrive early, test the whole setup including sound, turn off notifications (Focus Assist or Do not disturb), and keep a copy of your slides as a PDF on a flash drive in case the laptop fails.